Table of Content:

Checking alignment

There's a plug with a wire cross that inserts next to the head. For each corner, and the center: insert paper, fire laser, remove the paper, check dot.

The laser dot should be centered, and just below the horizontal - and it should be identical for each position.

Front to Back is off

Rear mirror needs alignment

• If mirror is higher at the front, mirror needs to angle downwards more.
• It's rare for this to need adjustment - it doesn't move under normal operation.

Left to Right variance

Gantry Y mirror needs alignment.

• if mirror is higher on right side, mirror needs to angle down further.

Adjusting the mirrors

• There are three screws - in a 90 degree formation.
• Do not turn the 'corner' screw - that shares an axis with both of the other screws.
• One corner for X, one corner for Y adjustments.
• Use thin paper over mirror.
• Start with mirror close to tube/previous mirror
• Hit laser, record dot. This is your Goal Dot for the other dot - you can't adjust the close dot much.